On This Page
FILTER BY TAG

Setting Up the PAX Terminal

This section describes how to set up the terminal. The product drawings show the PAX device features.

Figure:

PAX A77 Terminal Drawings with Features Labeled
PAX A77 Terminal Drawings of Front, Back, and Side Views; with Features Labeled

Figure:

PAX A50 Terminal Drawings with Features Labeled
PAX A50 Terminal Drawings with Features Labeled

Figure:

PAX A99 Terminal Drawings with Features Labeled
PAX A99 Terminal Drawings with Features Labeled

Figure:

PAX A6630 Terminal Drawings with Features Labeled
PAX A6630 Terminal Drawings with Features Labeled

Figure:

PAX A6650 Terminal Drawings with Features Labeled
PAX A6650 Terminal Drawings with Features Labeled

Remove the PAX Terminal Battery Seal

Before charging the battery and using the PAX terminal, you must remove the battery seal.
Follow these steps to remove the terminal battery seal.
  1. Find the battery cover on the bottom-rear of the terminal.
  2. To open the battery cover, slide the battery cover hatch to the opposite side of its current position.
  3. Note the orientation of the battery before removing it so that you can reinstall it correctly.
  4. Remove the battery and pull off the white plastic seal to expose the electrical contacts.

    ADDITIONAL INFORMATION

    Figure:

    PAX Terminal Battery Seal Location and Removal
    PAX Terminal Battery Seal Location and Removal
  5. Replace the battery in the terminal.
  6. Close the battery cover. Charge the battery before using the terminal. For more information, see Charge the PAX Terminal Battery.

Charge the PAX Terminal Battery

Before charging the battery and using the PAX terminal, you must remove the battery seal.
Have the connector cable and power supply unit provided with the terminal available.
Follow these steps to charge the PAX terminal battery.
  1. Connect the
    USB-C cable
     to the USB cable port on the PAX terminal.
  2. Plug the power supply unit into an electrical outlet. The terminal screen shows the charging status.

Power the PAX Terminal

Before you can power on the terminal, you must charge the battery.
Follow these steps to power the PAX terminal on and off.
  1. To power on the terminal, press and hold the
    Power
     button for 3 seconds until the device emits a beeping sound, and the LED next to the IC card slot lights. This light indicates that the terminal is powering on.
  2. To power off the terminal, press and hold the
    Power
     button for 3 seconds until the Shutdown menu appears on the terminal screen.
  3. Tap
    Turn Off
    . A message appears, confirming that the terminal is being powered off.

Insert the Paper Roll into the PAX Terminal Integrated Printer

The PAX terminal comes with one thermal paper roll that must be inserted into the device's integrated printer. The paper is used to print transaction receipts.
Follow these steps to insert the paper roll into the printer.
  1. Remove the protective seal from the paper roll.
  2. Find the printer hatch on the top-rear of the terminal.
  3. Open the hatch by pulling the printer cover switch toward the bottom of the device.
  4. Review the diagram on the inside of the hatch, showing the correct way to insert the paper roll.
  5. Insert the thermal paper roll as shown on the diagram.
  6. Pull out approximately 1 inch of the paper beyond the hatch. This action reduces the possibility of a paper jam when you print your first receipt.
  7. Close the hatch. When the paper roll is inserted incorrectly, an error message appears on the terminal screen.
  8. To tear off the printed receipt, pull the paper at a 45-degree angle against the integrated paper cutter.
RELATED TO THIS PAGE