On This Page
Access the Multifunctional Connector Cable Port on the PAX Terminal
Have a screwdriver available to remove the screws from the compartment
cover.
The multifunctional port is located in the compartment on the back of the PAX terminal. Access
the port so that you can connect the cable to the PAX terminal. For more
information, see Connect the Multifunctional Connector Cable to the PAX Terminal.
Figure:
PAX A35 Compartment
Follow these steps to remove the back cover and access the multifunctional port.
- Use a screwdriver to loosen the two compartment cover screws.
- Remove the screws and set them aside. You will reinstall the screws later.
- Slide the rear cover off the terminal to access the multifunctional port compartment.
- After you connect the multifunctional connector cable to its port in the compartment, replace the cover and screws.
- Tighten the screws to secure the compartment cover. Do not over-tighten the screws.